Samsung error codes

Confirm the model type first; clean only the documented filter area or stop for service if unsure.

Remove obstructions from the sump or spray path; service is likely if it returns empty.

Verify the hot water supply is not set too high before running another test.

Confirm the supply valve is open and the inlet hose is not kinked.

Check the drain hose, sink connection, garbage disposal plug, and filter area.

Check for dishes blocking the reflector or spray path.

Run one normal fill test only after checking supply, then stop if 9E returns.

If you are not connecting the dishwasher, turn it off and back on to leave AP mode.

Turn the dishwasher off and check that every button releases normally.

Power reset once and request service if CE continues.

Switch power off briefly, run a controlled empty test, and stop if HC returns.

Do not repeat heated cycles if HE returns; use service for heater or sensor diagnosis.

Turn off water if leaking is active and check around the door, base, and hose connections.

Cancel the cycle and watch for continued filling or draining problems.

Turn the dishwasher off and retry once; repeated PC usually needs service.

Run one empty half-load test only if safe, then request service if PE returns.

Empty the dishwasher and stop repeated tests if tE returns after a reset.

Remove items caught at the door and inspect the latch area.

Stop if there is a hot smell and verify airflow before another heated cycle.

Reduce the load and retry an empty short cycle only if the drum moves freely.

Open supply valves fully and check inlet hoses and screens.

Inspect the drain hose and clean the pump filter if your model has one.

Check the model manual and request service if 7E returns after a reset.

Confirm the washer is level and stop if the sensor code returns on an empty cycle.

Confirm the washer is on its own circuit and do not use an extension cord.

Stop repeated starts and have the circuit checked if the code returns.

Disconnect power for 5 minutes and request service if communication errors return.

Reduce the load and stop if the motor code returns on an empty test.

Clear the latch area and close the door firmly before restarting.

Confirm the Add Door is fully closed and the latch area is clear.

Check that laundry is not caught in the door and that the latch closes securely.

Stop if the washer overheats, smells hot, or trips protection; service is likely.

Cancel the cycle, watch for continued filling, and turn water off if needed.

Do not force repeated cycles if clutch-position codes return immediately.

Reset once after checking the outlet and breaker; stop if power drops again.

Power reset once, then check the model manual if the same code returns.

Let suds settle, run a rinse cycle, and use less HE detergent next time.

Power reset once; repeated temperature sensor codes should go to service.

Pause, redistribute the load, and avoid washing one heavy item by itself.