Bosch dishwasher error codes

Reset power at the breaker once; repeated E01 needs Bosch support or service.

Reset power once and stop if E02 returns, because board faults are service-level.

Power reset once; repeated E03 should go to service rather than repeated cycles.

Do not keep running heated cycles; contact support if E04 remains.

Check for obvious rack or spray blockage, then stop if E05 returns.

Check that the door closes normally and request service if E06 repeats.

Reset power once; repeated E07 is not a homeowner repair step.

Reset once; if it returns, stop repeating heated cycles and arrange service.

Avoid repeated heat-dry tests and contact support if E10 returns.

Use the model-approved descaling path and check water-softener salt guidance if equipped.

Check water supply first; service is likely if supply is normal.

Turn off water if leaking is active and check for visible leaks before resetting.

Check the inlet hose for kinks or damage and confirm the supply is on.

Check inlet hose condition and stop if the filling code returns after supply is normal.

Open the supply valve fully and inspect the inlet hose.

Power reset once; repeated E19 should be handled by service.

Do not force repeated cycles if the pump hums or the code returns immediately.

Reset power once and contact support if E21 returns.

Clean and reseat the dishwasher filter, then run a short rinse cycle.

Check simple drain restrictions first; repeated E23 usually needs service.

Check the filter, drain hose, sink air gap, and disposal connection.

Clean the filter and inspect the pump cover only as the manual allows.

Avoid repeated starts and have the outlet or circuit checked if it repeats.